Cost savings start with the drawing
When we receive a drawing, there are several design decisions worth reviewing before manufacturing the permanent mould. A geometry designed exclusively around machining may not be the most suitable for casting.
Sudden changes in wall thickness, excessively thick sections or an uneven distribution of material can make solidification more difficult and increase the amount of machining required afterwards. Considering the casting process from the outset helps prevent some of these problems.
Avoid using more material than necessary
More material does not necessarily mean a better component. Excessive wall thickness can increase weight, make solidification more difficult due to uneven thickness distribution across sections, and create areas that will subsequently need machining.
The aim is to ensure that every wall thickness serves a specific purpose, whether related to mechanical strength, leak-tightness, joining, machining or any other functional requirement of the component.
Tolerances are part of the design
Not every surface on a component requires the same level of precision. Specifying very tight tolerances where they are not functionally necessary can increase machining work and make manufacturing more complex.
For this reason, it is important to identify on the drawing which surfaces are critical and which can be achieved directly through the casting process.
Consider machining before casting
Cast components often require additional finishing operations. Shot blasting, tumbling, machining, polishing, impregnation or painting may all form part of the final production process.
The design should allow for the necessary machining allowances in the areas that will actually be machined, avoiding the need to remove large amounts of material afterwards. Coordinating casting and machining requirements is one of the decisions that can have the greatest impact on the final result.
Choose the right alloy
The choice of alloy should not be based solely on established practice. Brass and bronze alloys have different properties depending on the component’s requirements.
Mechanical strength, leak-tightness, wear resistance, temperature resistance and machinability can all influence which alloy is most suitable. If the application is not yet fully defined, this decision should be assessed before manufacturing the mould.
A well-designed component is easier to manufacture
Component design influences mould filling, solidification, shrinkage compensation and subsequent machining. This is why there is greater scope to improve a component while it is still at the design stage than once the mould has already been manufactured.
At Fundiciones Río Ebro, we work from 2D drawings or 3D files to assess the component, alloy and casting process together. This is the stage at which many decisions affecting cost and quality can still be changed.
What information should you provide to have a component reviewed?
A 2D manufacturing drawing, a 3D drawing or file, and/or a physical sample. It is also useful to know the component’s function, expected production quantity, estimated weight and any requirements relating to mechanical strength, leak-tightness, surface finish or machining.
Might a component designed for machining need modifications for casting?
Yes. Certain geometries, wall thicknesses and tolerances may be suitable for machining but less appropriate for casting. Reviewing them before manufacturing the permanent mould makes it possible to adapt the design to the different manufacturing processes.
Can I get advice on alloy selection?
Yes. The choice depends on the component’s operating conditions and the requirements it must meet. If you have not yet selected an alloy, this is one of the decisions we can review during the initial assessment.
Do you have a component in mind?
Send us your drawing or 3D file. We can review the geometry, alloy and casting process with you before manufacturing the permanent mould, identifying from the outset which design decisions could improve the component before production.
